(MK-0557-11.5) Belshaw Donut Robot Mark II, Mark V, and Mark VI Fryer Straight Drain Valve for Support Table (2 Variables in Variants)
Mark II or the Mark V/ Mark VI
Belshaw Fryer Drain Valve for the Supporting Table for the Donut Robot, The EZMelt Filter, and Rack Loader or Roto-Cooler. All Donut Robots except gas models have a short drain with a heavy duty metal cap attached to it, to close it off. This Drain and Valve can be attached to the fryer, instead of the threaded cap. To use the drain and valve, you will need: A hole in the table that holds your fryer to allow the drain and valve to extend through it, enough room under the fryer for the Drain and Valve. Extends 19" below the fryer, If you have this room, it will save A LOT of time and trouble emptying shortening. Instead of siphoning, just let the drain do the work. If you use the Drain and Valve when filtering shortening, you will need a filtration system to remove debris from the shortening. You can use a Belshaw EZMelt 18 or any other effective method. If you have room for the Drain and Valve, it will save A LOT of time and trouble emptying shortening. If you do not have this room under the fryer, the drain and valve will probably not help you, and you should consider the Filter Flo siphon (above) instead. The drain cap that comes standard is NOT designed to screw on and off when you empty shortening. Part # MK-0557-11.5
Extends 19" below the fryer
- Part # MK-0557-11.5 is a straight drain that extends 18 inches (45 cm) below the Donut Robot®, for use with a customer-supplied table for the fryer. It is recommended when the height of the table is more than 34.5 inch (88 cm).You will need to cut a 4-6 inch hole (10-15 cm) in the table to accommodate the drain. This drain is also used with the 'Insider'.